Lynx RaveTM 600, Operator'S Manual

Page: 104 / 134

DRIVE SYSTEM
Belt Guard Removal and
Installation

WARNING
NEVER operate engine:
– without shields and belt guard
securely installed
– with hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
NOTE: Belt guard is purposely made
slightly oversize to maintain tension on
its pins and retainers preventing un-
due noise and vibration. It is important
that this tension be maintained when
reinstalling.
Remove the tether cord cap (DESS
key).
Open engine compartment LH side
panel.
Remove retaining pin.
mmo2008-003-063_a
1. Retaining pin
Lift rear portion of guard then release
from front tabs.
When reinstalling belt guard, position
its cutaway toward front of snowmo-
bile.
Place belt guard slots over tabs first,
then snap the other end in rear retain-
er.
mmo2007-009-026_a
TYPICAL
1. Slots
Secure belt guard using retaining pin.
mmo2008-003-063_a
1. Retaining pin
Brake Fluid Level
CAUTION: Vehicle must be on a lev-
el surface before checking any fluid
levels.
Check brake fluid (DOT 4) in reservoir
for proper level. Add fluid (DOT 4) as
required.
CAUTION: Use only DOT 4 brake
fluid from a sealed container. Nev-
er use any other types of fluid.
102
_____________________