Lynx 800R E-TEC, Operator'S Manual

Page: 125 / 196

MAINTENANCE PROCEDURES
mmo2010-009-001_a
1. Opening
2. Feeler gauge
6. Place feeler gauge between engine
stopper and rubber stop block (on
engine).
NOTE: Do not insert the feeler gauge
too deep, as it will pass over the bump
at the surface of the rubber stop block
and alter adjustment. See illustration.
mmo2010-009-002_a
1. Rubber stop block
2. Bump
3. Feeler gauge
7. Tighten screws to specified torque,
following the illustrated sequence,
taking care not to pinch the feeler
gauge.
TIGHTENING TORQUE
Engine stopper
screws
10 N•m ± 2 N•m
(89 lbf• in ± 18 lbf• in )
mmo2010-009-007_b
TIGHTENING SEQUENCE
NOTICE
Serious pulley damage
can occur if the engine stopper and
its screws are not properly installed.
Brake Fluid
Recommended Brake Fluid
Use only DOT 4 brake fluid from a
sealed container. An opened container
may be contaminated or may have ab-
sorbed moisture from the air.
WARNING
Use only DOT 4 brake fluid from a
sealed container. To avoid serious
damage to the braking system, do
not use fluids other than the rec-
ommended one, nor mix different
fluids for topping up.
NOTICE
Brake fluid can damage
painted and plastic parts. Handle
with care. Rinse thoroughly in case
of spillage.
Brake Fluid Level Verification
NOTICE
Vehicle must be on a level
surface before checking any fluid
levels.
Check brake fluid (DOT 4) in reservoir
for proper level. Add fluid (DOT 4) as
required.
______________
123