LXE Akerstroms Tx700, Configuration Manual, Page: 26 / 146

Install Mounting Brackets Trux Configuration Guide
26 E-EQ-TRUXCONFIG-D-ARC
2.8.2.2 Step 2 – Prepare Tx700 or Tx800
The Tx700 or Tx800 is delivered with one or two RAM balls installed depending on the configuration
ordered.
If an integrated keyboard bracket is to be mounted to the rear of the Tx700 or Tx800, follow the procedure
below. Otherwise, skip to the next step.
1. The Tx700 or Tx800 must be off and the power cord should not be attached during this
procedure.
2. Place the Tx700 or Tx800 face down on a stable surface.
3. Remove the RAM ball from the back of the Tx700 or Tx800. The hardware attaching the
RAM ball is not reused.
4. Install the 2 M5x6 screws in the holes shown below.
Figure 8 Screw Installation, Tx700 or Tx800