LXE Akerstroms Tx700, Configuration Manual, Page: 105 / 146

Trux Configuration Guide Custom OS Installations
E-EQ-TRUXCONFIG-D-ARC 105
Communication – tab
On this tab you specify which serial port WLinq should use and the settings of the serial port.
Port
Specifies the serial port WLinq receive data from.
Speed
Specifies the speed in bps (bits per second).
Data
Specifies the number of data bits per character.
Parity
Specifies the data parity.
Stop
Specifies the number of stop bits.
DTR
Specifies the level of the DTR (Data Terminal Ready) signal. Used in combination with RTS to
signal status (handshaking) to equipment connected to the com port. Certain kinds of hardware
requires that the DTR and RTS are high before any communication will take place. The
communication speed of certain special hardware are configured by different settings of DTR and
RTS.
RTS
Specifies the level of the RTS (Request To Send) signal.
Default
Resets the serial port to COM1 and its settings to 9600, 8, No parity, 1, DTR=High, RTS=High.
Duplicate String Filter
Specifies whether WLinq should filter duplicate data input strings. If this setting is active, WLinq
will check the received data input string and if it is the same as the previous data input string and
the specified time hasn't elapsed, the string will be filtered (removed).
Hardware Pin Events
Configure serial port hardware signals to generate events.
Note! The hardware you connect to the serial port must be set to use the same speed, data bits,
parity, and stop bits.