18
Step#2 Releasing Door Latch
Step #3 Lifting the Glass Door Assembly
from Locator Tab
1)
Remove the Control Valve Compartment cover grille which provides access to the door latch
mechanism
2)
Door latch mechanisms located on the lower edge of the glass door are pulled forward then moved
down. The latch is spring loaded so sufficient effort is required to clear it from the door frame
before it will release.
3)
Holding the bottom edge of the door frame tilt out the door assembly 4-5” then lift up to slide the
frame off the two retaining tabs located at the top of the Fire Box Enclosure
WARNING: Do not abuse the appliance’s glass by striking, slamming or similar trauma. Do not use the
appliance with the door removed, glass panel cracked or broken. Only use OEM door assembly designed for
use with this appliance. Do not use substitute materials. Replacement of the panel should only be carried out by
a licensed qualified service person
Door Removal and Re-Installation Instructions
Window Re-Installation
To Re-install the Glass Door Assembly it is simply a reversal of the removal procedure. Hold the Door assembly at
about a 45
°
angle and line up the two top slots located on the frame top edge onto the two retaining tabs (shown in
illustration). Once in the grooves, the door should simply close down into place. If the assembly is not aligned well
some adjustment to the left or the right may be required to permit proper closure. DO NOT FORCE ASSEMBLY!
When Door assembly is aligned pull latch mechanism forward and up to secure door. Replace the Valve Compartment
Grille
Picture of cover grille here
NOTE
: In the event of glass fracture or other related damage the Glass door must be replaced as a
complete assembly. The Robax Glazing/Frame Assembly must be provided bt Canadian Fire
Hearth Mfg.only. Part #RGD42RIV.
grille
