Commissioning
26
© Lutz-Jesco GmbH 2020
BA-46020-02-V04
Multi-Channel Controller
TOPAX
®
MC
Operating instructions
Configuring the password protection
Fig. 22: Configuring the password protection
Perform the following work steps:
1.
Press the lock icon in the left-hand upper corner to configure the
password protection.
2. Password active:
Select whether password protection should be ac-
tivated or deactivated. Password protection can only be deactivated if
you are logged in to level 3.
4
Password protection must be activated to unlock the following
steps.
3.
Select one of the three password levels into which you wish to log on.
4. Login:
Login with the password for the password level previously se-
lected.
5. Change password:
You can edit the password of the level in which
you are logged in.
ü
Password protection configured.
8.4 Network settings
You may need to perform settings in order to be able to use the device in a
network.
Further information about using the device in a network can be found in
section 9.7 “Access via network” on page 34.
Perform the following work steps:
1.
In the main menu under System > Service, navigate to the “Network”
tab.
2.
Working in the “Network” tab, configure the interface and state the
following information.
3. IP address:
Give the device a unique IP address through which it can
be reached in the network. If this IP address is already being used by
another device, errors can result.
4. Subnetmask
Enter the subnetmask.
5. TFTP server:
“On” = Access via TFTP protocol activated on the de-
vice memory. “OFF” = Access via TFTP protocol de-activated on the
device memory.
6. Modbus RTU address:
Enter a number between 1 and 14 in the de-
vice if your device is fitted with a RS485 network connection.
ü
Network settings performed.
