![Lutron Electronics Sivoia QED Technical Reference Manual Download Page 26](http://html.mh-extra.com/html/lutron-electronics/sivoia-qed/sivoia-qed_technical-reference-manual_1950784026.webp)
Sivoia QED
TM
(quiet electronic drive) Shading System
2.9
24/7 Service and Support: 1-800-446-1503
how to measure
|
in-line coupling
Fabric Width
Fabric Width
Fabric Width
System Width
System Width
System Width
1.5 Fabric Gap
1.5 Fabric Gap
3/4
3/4
Coupled shades may provide a means to reduce the total
installed cost of the Sivoia QED system. The number of EDUs on
a job may be reduced where independent control of adjacent
shades is not needed. With a reduction in the number of EDUs
there will be an equal reduction in transformers and wiring.
This may also simplify the programming and setup of the job.
In an in-line coupled system, one EDU is lifting up to three fabric
panels. The EDU can lift aproximately 100 square feet of fabric.
For a specific application, use the Shade Configuration Tool
(available at www.lutron.com) to verify that dimensions and
fabric panel sizes fall within the scope of the Sivoia QED system.
With the in-line coupled system, up to three shade panels can
be operated from a single EDU. A coupling pin provides for
phase adjustment that allows the installer to adjust the hembar
alignment after installation and without removing the fabric
panels from the tube. Likewise, the in-line coupled system
provides the same leveling, shade centering, and projection
adjustment that is provided on the single roller Sivoia QED
shade. Also, in-line coupling is supported for all five mounting
conditions: wall, ceiling, jamb/recess, fascia, and pocket. Fabric
gaps are shown in the illustration below.
MECHANIC
AL COMPONENTS