Lutron Electronics QSPS-P2-10-60, Installation Instructions Manual, Page: 8 / 16

4
4.1
Wiring the QSPS-P2-10-60
Run low voltage wire into the QSPS-P2-10-60
Remove as many knockout
tabs as necessary from the
left side of the enclosure and
insert strain reliefs.
Run the low-voltage
communication wiring from
the Lutron QS shade and
lighting devices through
the strain reliefs to the
terminal blocks.
Strip insulation wire so that
7 mm (.25 in) of bare wire is
exposed. Make sure to
tighten the screws tightly
and that no insulation is
inside of the terminal block.
Input power from distribution panel
Hot (Live)
Neutral
Earth Ground
Low voltage wiring
(To Lutron shade and
lighting components)
1
1.1
Page 7
Sivoia
®
QS QSPS-P2-10-60 (CE) Installation instructions