Lupus Electronics XT 1 Plus, User Manual

Page: 315 / 332

315
Connecting the vibration sensor and putting it into operation
1.
Remove the battery breaker.
2.
Open the main menu of the alarm panel.
3.
Open the menu “Sensors”

“Add”.
4.
Press “Start”.
5.
Press the learn button (1) of the vibration sensor for a couple of seconds. The red
LED (2) will flash.
6.
The alarm panel will confirm the successful addition with a brief signal tone and
display the Shock sensor in the menu “Sensors”
 “Add”. Click on next to the
sensor to finish the connection process.
Range test:
1.
Open the alarm panel menu “Sensors”  “Range” and press “Start”.
2.
Press the learn button.
3.
The sensor and the signal strength should be indicated. The higher the indicated
number the better the reception (1-9).
Please note:
If the signal strength at the place of installation is below 4, we advice to use a
repeater, since it is normal that the signal strength may fluctuate for 2-3 points,
thus, a signal loss is possible.
Installation:

Before you install the sensor, check if the surface you want to install it on is clean
and even.

If you want to secure a door or a window by means of the Shock sensor, you
should use the provided adhesive tape to install the sensor on the window or
door (the moveable part).

Make sure that you can still access the battery compartment after you have
installed the sensor.