Lupus Electronics XT 1 Plus, User Manual

Page: 234 / 332

234
armed during this time, the relay will close again.
Please note:

The relay of the outdoor keypad reacts upon mode change of the alarm panel
(via browser, keypad, remote control, smartphone, etc.) as long as the outdoor
keypad is powered by the mains adapter. If the outdoor keypad is only powered
by the batteries, the relay will only react when the mode changed is performed by
the outdoor keypad.

If you want to define the relay for area 2, you need to start the learn mode again
(enter the installer mode and, then, press * + 7) and define the outdoor keypad
for area 2 in “Sensors”
 “List”  and save this setting by clicking on “OK”.
Afterwards you need to end the installer mode again.

The relay can only be triggered by one area.
Tag configuration
You can learn up to 100 tags to the outdoor keypad (regardless of area 1 or 2) and link
them to the PIN codes. Afterwards, you can use the learned tags to operate the outdoor
keypad.
Learn tags
1.
Start the learn mode by entering the installer code of the keypad (default 0000)
and then press the * key.
2.
Enter * + 1 in the keypad to start the tag configuration mode. The Status LED lights
up red.
3.
Enter a PIN code you have already defined via the menu “Alarm system”  “PIN
codes” and press the hash key (#). An audio signal sounds and the tag reader
lights up for five seconds.
Please Note:
If a PIN code is linked that has not been entered in the alarm panel, it can be
entered retroactively via “Home”
 “PIN codes.”
4.
To connect a tag to the entered PIN code, hold the tag to the tag reader (4) as long
as the tag reader is illuminated.

If the tag is new, the keypad will beep twice.

If the tag was already added, the keypad beeps only once. If, however, the tag
is linked to a new PIN code, the old link is removed.

Any further tag learned to the outdoor keypad this way extends the tag learning
phase by further five seconds.

If the tag reader switches off too fast, start again with step 3.

Press the disarm button to exit the tag configuration mode. The status Led
does not light up red anymore.

Press the disarm button again twice to exit the installer mode as well.
Note:
The outdoor keypad emits four quick successive beeps in case of the following problems:

The entered PIN code is wrong.

100 tags have already been integrated.
Remove tags
You can unlearn the already learned tags as follows:
1.
Start the tag configuration mode as described above. The status LED lights up red.