Lupus Electronics XT 1 Plus, User Manual

Page: 146 / 332

146
Alarm test
After installing the alarm panel, you can simulate an alarm in order to test the function of
the individual sensors and if the alarm panel reacts as you want it to. We advice using a
door contact for this test.

Check if the sensor is set to trigger an alarm in the mode you want to test
(“Sensors”
 “List”  “edit”).

Set the alarm panel to arm or home (depending on which mode you want to test).
How you change the mode (keypad, browser, app, etc.) is not of importance.

Check if the mode was changed correctly and also mind the exit delay that was
set (“Alarm system”
 “Settings”  “Area settings”).
You can check the current status of the alarm panel in the menu “System” 
“Status” or via right mouse button / Control menu  “Mode change”.

Trigger an alarm by opening a door contact.
Please note:

Due to the loudness of the sirens, you should end the alarm shortly after you
triggered it by disarming the alarm panel.

Tell you neighbours in advance that you are going to perform a test of your alarm
panel.

Check if the internal siren of your alarm panel, as well as, your external sirens
sound the alarm. If this is not the case, check the logs if an alarm was triggered
(“System”
 “Logs”  “System events”). If an alarm was triggered but the sirens
did not sound, check the menu “Alarm system”  “Siren settings”  “Alarm
settings”.

Check if the set up notification methods worked (e.g. SMS, E-Mail). If you did not
receive a message, check if the test message function works. If the test works,
check the filter options set for the corresponding messaging method.

The alarm panel receives information from the sensors every 30-50 minutes.