48
49
Wilma
Wilma
Deut
sc
h
Engli
sh
7
8
Special Functions
Product care and storage
Normally the plug contacts are maintenance free. However, if you use your Wilma light in humid, salt-
air, environments, it’s advisable to apply a thin layer of
Lupine Dutch Grease
to the contacts every so
often to prevent oxidation.
Do NOT use terminal grease or contact spray.
Important:
Always keep the battery separate from the Wilma light,
because otherwise the small
amount of power used by the electronics will discharge the battery, and the lamp may switch on
accidently.
Important!
Moreover, the consequent uncontrolled heat buildup could cause a fire or
melt the adjacent plastic material. Could cause fire or death
!
During lengthy periods of non-use, fully charge the battery and store it in a cool, dry place, basement
or the like. The battery can be kept plugged into the charger if desired.
Open the light housing’s front screw-on cover. Grasp the rear section of the lamp with one hand while
rotating the front section of the cover to the left (counterclockwise) with the other hand. Once you
have removed the cover, you will see the 4-array lens. Do not touch it.
Check to ensure that the O-ring on the rear section of the housing is correctly positioned.
The housing will only be waterproof if its O-ring is intact. After completing this inspection, carefully
screw down the housing cover.
Important note:
if the thread runs smooth, the cap is in the right
position. Otherwise please stop and screw back the cover and try again, otherwise you might
damage the thread.
Plug contacts:
Transport:
Storage:
Opening the frontcap:
Closing the frontcap:
Use this program to adjust the onset of the low-battery warning.
Press and hold the button for until 4
green LEDs
light up.
release the button.
The threshold can be selected as shown below.
2.
1.
Adjusting the low-battery warning LEDs:
2.
Recover factory settings:
Press and hold the button until
5
red
LEDs
turn on.
release the button.
1.
Disconnect the battery, and all factory settings will be restored.
Factory setting
6.2 V
5.8 V
6.4 V
6.0 V
6.6 V
6.2 V
6.9 V
6.5 V
7.1 V
6.8 V
Lamps backlight and remote:
red
blinking
red
Bluetooth module:
The housing of the Bluetooth module on the underside of the lamp head may
only be opened by Lupine or authorized distributors.
