38
39
Wilma
Wilma
Deut
sc
h
Engli
sh
Operation
3
3
Lamphead display:
The remaining capacity will be shown in detail on any Lupine Smartcore battery (see
page. 33). Additionally, the LEDs on the back of the lamp-head change color to indicate
decreasing voltage. When battery voltage drops below a certain level, the Backlight LED
changes from blue to green. Near the end of the battery’s charge, the light turns red.
LEDs blue or green
Backlight red
Low
capacity
Safe power
LEDs blue or green
Backlight blinks red
Very low
capacity
Use low light!
Reduce speed!
At 10W to 28W
1 up to 5 blue LEDs
Backlight blue
At 0.3W to 7W
1 up to 5 green LEDs
Backlight green
LED display Bluetooth remote:
Remote red
Remote green
Remote blue
Remote blinks
red
Use low light!
Reduce speed!
Safety advisory:
When the battery is completely discharged ( all 5 red LEDs blink
with a red backlight on), the light will shut down after flashing a few times. In such
a case, you should
stop riding your bicycle immediately.
Note:
The battery time remaining after the green or red LED backlight turned on depends on total
battery capacity, the ambient temperature, the battery’s age, and which setting is used. Moreover,
since the voltage curve of a Li-Ion battery is not proportional to the power left in the battery, you
need to learn how to interpret the relevant displays for your specific battery.
Safety advisory:
Do not switch on the light when the battery
is discharged, as this will invariably
damage the battery.
Recharge the battery as soon as possible to avoid a deep
discharged battery.
Empty battery and reserve power:
When the battery is completely discharged (all 5 red LEDs blink with a red
backlight on), the light will shut down after flashing a few times!
To activate the battery’s reserve power, doubleclick the switch. This will
give you a few minutes more light, whose exact amount depends on the
age of your battery. The light emitted in reserve-power mode is a very low
beam so as to conserve power and keep the light going as long as possible.
The red 5 LEDs slowly flash when reservepower mode is activated and
the backlight will be red.
When the reserve power has been completely
discharged, the light will shut down – which means that you to slow down.
Note:
If only 2.0 W or less was used, reserve power is not available!
Battery empty
5 red LEDs blinking
Backlight red
Remote blinks
red/blue
