Lunos Gesture Control 5/GS, Installation Manual

Page: 11 / 32

11
Safety instructions
Caution! Any assembly work may only be carried out after disconnecting the supply
voltage!
Make sure that the supply voltage of all connection lines is voltage-free (dead)!
(Separation from the power supply with a minimum contact opening of 3 mm, e.g.
electric fuse).
Each electric circuit of this ventilation system must be fitted with a residual current
protection (e.g.FI switch).
Electrical connection only by a specialist!
Additional installations and electrical components in the ventilation unit are not allowed!
Electrical connection EN
Notes regarding the connection diagrams:

For reasons of clarity, the connection of 5/UNI-FT, Ne
xx
t and Silvento ec is
shown separately in the connection diagrams; you can, of course, also connect
two different devices to the gesture control at the same time.

Simultaneous digital and analogue control is also possible. Please note that the
device to be controlled digitally is connected to T1 and R1 and the device to be
operated via analogue control is connected to R2. The DIP switch 4 of the 8-
way DIP switch must then be set to ON and the DIP switch "D/A" to the right to
"A".