Luneau Technology Briot emotion2, Instruction Manual

Page: 46 / 162

Using your Edger...Usual procedure
3-45 LTO
3.2.5.2 L
IMITS OF HOLE POSITIONING

Whatever the type of hole, it must be drilled in a specific zone which is defined following the diagrams below.

The following constraints must be observed:

The circle radius beyond which drilling is possible:
Note : When it is impossible to drill a hole (hole positioned in the end-pieces, notch passing
through the centre of the shape, this hole is shown in black in the screen. 
Some holes displayed in blue in the screen may be impossible to drill after they
have been felt (holes too deep, unadapted angle, unadapted end-piece, etc.).

The ring formed by the edge of the lens and the internal perimeter of the lens beyond which
drilling is not permitted:
A
LL HOLES
,
WHATEVER THE TYPE
,
MUST BE WITHIN A
10
MM RING
.
Zone inside which drilling is no permitted.
Zone inside which drilling is permitted.
Min. distance from centre of block centre of
hole = 17.75 mm
Max. distance from drill bit centre -> edge of
lens = 10 mm
Zone inside which drilling is no permitted.
Zone inside which drilling is permitted.