Luneau Technology Briot emotion2, Instruction Manual

Page: 122 / 162

Maintenance...Adjustments
5-121 LTO
#7 At the end of the edging process, open the lens holder shaft and remove
the lens.
#8 Measure the size of the lens with a caliper.
#9
#10 Enter the value using the number key pad.
#11
#12 OR
#13 Fit the lens on the lens holder shaft again.
#14
#15 At the end of the edging process, open the lens holder shaft and remove
the lens.
#16 Measure the size of the lens with a caliper.
#17
#18 Enter the value using the number key pad.
#19
#20 Check the position of the apex of the bevel with a linen-counter. 
The apex must be in the centre of the edge of the lens.
#21 


#22 If the apex of the bevel is off-centered, enter the value of the shift
using the number key pad.
• Apex too close to the rear face => enter a negative value
• Apex too close to the front face => enter a positive value
Repeat the edging process
> Lens edged to 55 mm diameter - Rimless finishing
Follow the
usual procedure
> Lens edged to 50 mm diameter - Bevel finishing