Lunar Caravans Landstar 2017, Handbook

Page: 44 / 108

8-26
SERVICES
Press and release the button to move the
step in or out. One press of the button will
move the step out, a further press will move
the step in again.
If the engine is started the step will move in
automatically, after a short warning buzzer. If
this operation fails due to an obstacle or
mechanical failure a buzzer will sound
continuously to warn that the step is still in
the out position, and therefore requires your
attention.
The electric step is also linked to the remote
door locking. If the doors are unlocked the
step will move out, if the doors are locked the
step will move in. This is a dealer
configurable item, and can be turned off if not
required.
3.11 System Warnings
The system incorporates a number of warnings that are active at specific times. These are
summarised below, and also covered by relevant sections of this manual.
Warning When Type
Fresh water level low With pump turned on and fresh water Message on screen and 1 minute
level low (less than 25% full) audible beep
Waste water level full With pump turned on and waste water Message on screen and 1 minute
level full (tank level 100%) audible beep
Vehicle battery voltage With control panel power on and vehicle Message on screen and 1 minute
low battery selected (as active battery) and audible beep. If no action taken after
voltage level below 10.9V 1 minute then the system will switch to
the leisure battery
Leisure battery voltage With control panel power on and leisure Message on screen and 1 minute
low battery selected (as active battery) and audible beep. If no action taken after
voltage level below 9V 1 minute then the system will switch
the power of to prevent over discharge
of the battery
Alarm clock active When alarm has been turned on and Message on screen and 1 minute
alarm time has been reached audible beep
Engine running When the engine is started the system Message on screen, on EC480 this
power will be turned off will remain visible for 1 minute
Step still out When the engine is started and the step Message on screen and rapid beeps
has failed to retract automatically from the control panel. The beeping
will not stop until the fault is cleared.
Mains lead (hook-up When the engine is started and the Message on screen and repeated
cable) still connected / mains cable is still plugged in and beeps from the control panel. The
plugged in switched on beeping will not stop until the fault is
cleared.