17
After Sales Support
Telephone: 1300 366 144
Internet: [email protected]
To clean the filter, proceed as follows:
• Remove the respective filter as described above.
• Tap the filter above a dustbin to empty it.
• If it is very dirty, clean the filter thoroughly with water (water should not be more than lukewarm) and then
allow to dry completely.
• After cleaning and drying the foam filter and the fine dust filter, fit to the foam filter precisely back in the filter
holder (with the fine dust filter).
• Place the filter holder back in the appliance by first pushing it up into the recess provided for it and then
pressing it until it snaps into place.
• Now put the filter cover back in by first guiding the pins on the top of the filter compartment into the ope-
nings provided for them and then pressing towards the appliance on the underside until you hear and feel
the catches snap into place.
Cleaning the exhaust filter
Do not clean the exhaust air filter in the dishwasher. Do not use warm water, detergents or brushes.
You should clean the exhaust air filter (K) regularly, depending on the nature and frequency of use. It is located
behind the protective cover for the rear left wheel (appliance viewed from behind).
• Turn the protective cover anticlockwise as far as it will go and remove the cover.
• Pull the exhaust air filter (K) out by the strap provided for this purpose, as shown in
image 12.
• Tap the exhaust air filter (K) out carefully over a dustbin, as shown in image 12.
• If the exhaust air filter very dirty (K) wash it thoroughly with water (water should not
be more than lukewarm) and then allow it to dry completely.
• Allow the exhaust air filter (K) to dry completely at room temperature before you put
it back in the appliance.
• Put the completely dry exahust air filter (K) back in the machine, as shown in image
12.
• Push the protective cover as far as it will go into the appliance so that the “lugs” on the protective cover en-
gage in the recesses provided for them. Make sure that the “lugs” and the recesses are of the same width.
• Then turn the protective cover clockwise as far as it will go until you hear and feel it click into placeCheck
that it is seated correctly. Make sure that the connection is secure.
Image 12
