16
After Sales Support
Telephone: 1300 366 144
Internet: [email protected]
Cleaning the coarse dust filter
Never immerse coarse dust filter in water.
Do not use any detergents.
Do not reinsert the coarse dust filter until it is completely dry.
The coard dust filter (B) inside the dust container (A) should be cleaned regularly.
To remove the coarse dust filter (B), proceed as follows:
• First take out the dust container (A) and empty it as described above.
• Hold the dust container (A) firmly and turn it anticlockwise by the handle (E) until the
arrow on the cover points towards the “Open lock” symbol on the dust container (A).
• Pull the cover with the coarse dust filter (B) up and out of the dust container (A), as
shown in image 10.
• Knock dust residue off over a dustbin.
• Particles that are stuck more firmly can be cleaned off with a soft brush or a damp cloth.
• Allow the coarse dust filter (B) to dry completely.
• The insert the coarse dust filter (B) back in the dust container (A) so that the arrow on the cover is aligned with
the “Open lock” symbol on the dust container (A). The dust container flap (C) should be open.
• Now turn the cover anticlockwise as far as it will go. The arrow on the cover will now be aligned with the
“Closed lock” symbol on the dust container (A).
• Close dust container flap (C) again.
Handle
Coarse dust filter
Cleaning the motor protection filter
Do not clean the motor protection filter in the dishwasher. Do not use warm water, detergents or brushes.
The motor protection filter consists of foam and a fine dust filter that is attached firmly to the filter holder
and should be cleaned regularly, but at least when the suction power starts to diminish. The motor pro-
tection filter can be accessed while the dust container has been taken out.
• First take off the filter cover. This is located under the dust container. To do this, use
two fingers to raise the catches that are attached to the underside of the filter cover
and take off the filter cover towards the front of the appliance.
• Now take out the filter holder in which the foam filter is seated. To do this, reach into
the recess at bottom right and gently press the filter holder upwards, then pull it out
towards the front of the appliance.
• Take the foam filter out of the filter holder, as shown in image 11.
Image 10
Image 11
