Lumikit Sistemas para Iluminação
Lumikit Sistemas para Iluminação
Lumikit Sistemas para Iluminação
Lumikit Sistemas para Iluminação | www.lumikit.com.br
11
1111
11
If the DMX update rate is low, it’s possible to increase the value in the field “Hardware update rate”, most of the
systems Works well with 30 fps (frames per second). The ideal is to test in practice, checking if the lighting
stops responding at some point, in this case it is better to use lower values.
3.2.2 UNICAST
3.2.2 UNICAST
3.2.2 UNICAST
3.2.2 UNICAST Mode
Mode
Mode
Mode
Before starting
Before starting
Before starting
Before starting
any configuration
any configuration
any configuration
any configuration
,
to
to
to
to use the UNICAST mode check if the IP number of your board is in the same
use the UNICAST mode check if the IP number of your board is in the same
use the UNICAST mode check if the IP number of your board is in the same
use the UNICAST mode check if the IP number of your board is in the same
network class as the IP number configured in the interface, for example
network class as the IP number configured in the interface, for example
network class as the IP number configured in the interface, for example
network class as the IP number configured in the interface, for example: : : : if the
if the
if the
if the interface
interface
interface
interface IP
IP
IP
IP is
is
is
is 192.168.0.30,
192.168.0.30,
192.168.0.30,
192.168.0.30, your
your
your
your
network card used to
network card used to
network card used to
network card used to com
com
com
comm
m
m
munica
unica
unica
unicate
te
te
te with the
with the
with the
with the interface
interface
interface
interface must have an
must have an
must have an
must have an IP
IP
IP
IP 192.168.0.???
192.168.0.???
192.168.0.???
192.168.0.??? ranging
ranging
ranging
ranging from
from
from
from 1
1 1
1 until
until
until
until 254
254
254
254
(exce
(exce
(exce
(except
pt
pt
pt 30).
30).
30).
30). Otherwise the communication with th
Otherwise the communication with th
Otherwise the communication with th
Otherwise the communication with the interface will not be possible.
e interface will not be possible.
e interface will not be possible.
e interface will not be possible.
The interface and the network card must have the same subnet mask number. Check the final chapters in the
manual to know the procedures of IP changing in your computer.
To check if the communication with the interface is working, simply enter, in the command prompt, the
command ping 192.168.0.30 ( or the IP address configured in the interface, if it was changed):
To use the UNICAST mode it’s importante that there is na answer from each network interface PING,in case this
is not possible, must be checked the settings of the network, routers (access point/ switches, as a last resort
try with another router model), interfaces the computer itself (probably the firewall or any antivirus is blocking
the communication). Remembering that if only 1 interface is used in the network, or if all interfaces use the
same Art-Net universe the BROADCAST mode may be used (chapter 3.2.1).
In case the net is properly configured and the PING answering, the setting of the interfaces inside the software
is simple, in software Lumikit SHOW (or Lumikit LED), do the following procedure:
a)
Click in the button “Interfaces”, at the top right side;
b)
In case there is any interface in the list, click in “Remove All”;
c)
In displayed window “Interface settings”, click “Auto” (2) and after a few seconds the interfaces must be
automatically located: