OPERA
TING
INSTRUCTIONS
MAJOR PARTS
TROUBLESHOOTING
CUSTOMER SUPPORT
& W
ARRANTY
RA
TINGS &
SPECIFICA
TIONS
IMPORT
ANT SAFETY
INSTRUCTIONS
한
국
어
日
本
語
简
体
中
文
繁
體
中
文
English
5
4
After using the device, hold down the
power button to turn off the power.
Next, remove the power cord from the
outlet by pulling from the plug.
[When finished using this device]
*Hot air from the device may cause chemical
changes and/or hair damage when applied
to hair treated with coating agents or oils.
*Do not touch the nozzle of the device, which
may be hot during or after use.
*If hair gets too close to the air intake, it may
get sucked in the device. Use with caution.
Insert the power plug
into an outlet.
4
Select wind speed.
Make sure that only this device is plugged into
an outlet with a rating of at least 15A.
Make sure to insert fully. Be sure that the
power plug is not loose.
［Before Using］
General Operation
Use a towel to remove excess
water after washing your hair.
For more information,
please access the official website below:
Bioprogramming Club Official Website
This device is equipped with
an automatic off switch.
It will turn off by itself after 60 minutes.
In order to turn the device on again, press the power button.
Light
PUSH
Blinking
Securely
●
●
●
Once the power button is pressed, the
device will switch to stand-by mode
and the Power Light will blink.
After confirming the power is off,
remove the power cord from the outlet.
Make sure to grasp the plug when
pulling the power cord.
Hold the plug
Press this button to switch between
cool and hot air.
Run your fingers through your
hair while drying to ensure
that hot air reaches the roots.
OPERATING INSTRUCTIONS
Temperature Switch Button
♪
Wind Speed Buttons
To Stop the Wind
Wind Speed
lights are white
The wind speed will change
by pressing either 1 (Low), 2
(Medium) or 3 (High)
Blue Light
Red Light
Press the button of the wind
speed which you are currently
using to stop the wind.
（ High ）
( Medium ）
( Low ）
Hold
(for two seconds)
Ending
Melody
PUSH
Red light
blinks
bioprogramming-club.jp
Turn on device.
Stand-by Mode
When the power plug is inserted
into an outlet, the device will be
in stand-by mode.
A red light will softly blink.
♪
Red light
blinks
Start-up
Melody
Red Light
PUSH
Blue Light
