IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be followed to prevent
any risk of personal injury or death.
1.
Never allow the spa to be used with less than two (2) people present.
Someone should be present in case the bather requires assistance due to injury, cramping, drowning, etc. Children should
never be allowed to use the spa without the direct supervision of a responsible adult.
2.
Always use care in and around your spa.
The spa has many rigid, unyielding parts and many areas become wet and slippery; these are all potentially dangerous
when rough play is allowed or if care is not used particularly when entering or leaving the spa.
3
.
Always use the appropriate outlet.
This unit is equipped with a 3-pin 120V 15A ground-fault circuit interrupter (GFCI). Always plug this equipment into an
appropriate outlet. The GFCI should only be plugged into a dedicated 110-volt /15-amp outlet.
4.
Prevent unauthorized access – Risk of Accidental Drowning
Extreme caution must be exercised to prevent unauthorized access by anyone, especially children. To avoid accidents, en-
sure that children are prevented from using this spa unless they are supervised by an adult at all times.
5.
Replace broken or missing drain cover immediately – Risk of Injury.
The suction fittings in this hot tub are sized to match the specific water flow created by the pump. Should the need arise
to replace the suction fittings or the pump, be sure the flow rates of the new fittings are compatible. Never operate the hot
tub if the suction fittings are broken or missing. Never replace a suction fitting with one having a lower flow rate than the
original suction fitting. Always use new, pristine, unrefurbished parts in your hot tub. Accidents can occur when long hair or
a body part becomes suctioned into a drain or outlet because the cover has been removed or is broken or blocked. Be sure
to clean the faceplate regularly. Children are particularly vulnerable, and they should be warned against this danger.
6.
Install away from all metal surfaces – Risk of Electric Shock.
In most case, the unit must be installed at least 1.5 m (5 feet) from all metal surfaces. As an alternative, a hot tub may be
installed within 1.5 m (5 feet) of metal surfaces if each metal surface is permanently connected by a minimum of 8 AWG
(8.4 mm²) solid copper wire conductor to the wire connector on the power pack provided for this purpose,
Consult city, county, state/provincial, and federal regulations for applicable requirements. Be sure to check with your local
agencies for specific requirements
7.
Keep electrical applicances away from spa – Risk of Electric Shock.
Do not allow any electrical appliance, such as a lamp, telephone, radio, television, etc, to be placed within 1.5 m (5 feet) of
a spa or water.
8.
Keep the water clean and sanitary at all times.
Your filter system will remove suspended particles from the water. Regular application of spa chemicals in proper quantities
will destroy harmful bacteria and prevent algae from forming. Your surface skimmer will remove insects, leaves, and other
debris from the water’s surface. Unsanitary water is a serious health hazard and so are unbalanced chemicals. Please see
your retailer for appropriate chemical balance to be maintained.
Accidents can occur when long hair or a body part becomes suctioned into a drain or outlet because the cover has been
removed or is broken or blocked. Be sure to clean the faceplate regularly. Children are particularly vulnerable, and they
should be warned against this danger.
THE GFCI SHOULD BE PLACED IN A DRY, SAFE PLACE
5
Summary of Contents for spa-O
Page 23: ...23...
