19
TROUBLESHOOTING TIPS
Q.
*How do I program my topside?
A.
*not applicable for pre-programmed spas. Upon initial start up, your spa will go into priming mode, Pr. This will last for 5
to 7 minutes. Once the priming cycle has completed you can set your spa as desired. The Controls Reference Guide Section
of this Owner’s Manual provides step by step guidelines on how to set up your spa.
Q.
Who do I contact for servicing and/or troubleshooting my Spa?
A.
For servicing and troubleshooting, you should contact the dealer where you purchased your spa. Your sales agreement
will provide dealer contact information.
Q.
Can I use de-foamer in my spa?
A.
You should only use recommended chemicals to maintain your water balance. Your dealer will provide you with all the
chemicals you need as well as precise instructions on how to balance your pH, bromine and calcium levels to maintain
your spa in pristine condition.
TROUBLESHOOTING TIPS
In the event your SPA-Ô is not working the way it should, first review all the installation and operating instructions in this
manual. Check the message on the display panel and follow the appropriate troubleshooting instructions.
Note: If any of the manufactured installed supply cords are damaged, they must be replaced by authorized
servicing personnel.
NONE OF THE COMPONENTS OPERATE :
Check the following :
1.
Is power being supplied to the hot tub?
2.
Is the household circuit breaker tripping?
3.
If the answers to 1 & 2 are yes, call Lumi-O or your authorized dealer for service.
PUMP DOES NOT OPERATE, BUT THE LIGHT DOES
Press the JETS button:
The pump operates but no water flows to jets. Pump may not be properly primed. This can happen after the spa is drained
and refilled. Press the JETS button several times, never leaving the motor on for more than 5-10 seconds at a time.
POOR JET ACTION
1.
Press the JETS button to make certain the pump is on.
2.
Rotate the air control to the Max position.
3.
Make sure the water level is adequate.
4.
Check for dirty filter. Clean, if necessary.
5.
Make sure all jets are in the Open position
Summary of Contents for spa-O
Page 23: ...23...
