Connecting the Footswitch
Lumenis Pulse 120H UM-10012510 Rev. F
Page 41
Connecting the Footswitch
1.
Insert the footswitch connector into the footswitch receptacle on the
rear of the Lumenis Pulse 120H laser console. Align the red dot of the
footswitch connector with the red dot of the receptacle, then push it in.
Figure 8: Connecting the Dual-Pedal Footswitch
NOTE:
If the footswitch is not properly connected when the laser is turned on,
Foot pedal is not connected
appears in the notification bar until the
footswitch is properly connected.