BS305/BS340 13
OPERATION
Fence height can be lowered when
cutting thin materials
– Loosen the two knobs G.
– Slide the fence out from fence support.
–Rotate fence 90
°
.
–Insert the lock screw into other groove of the
fence.
–Retighten the two knobs G.
Fence can be adjusted paralleling with the side
of blade by loosening the two socket bolts H.
Using mitre gauge
The mitre gauge is inserting into the table slot
from the table front edge.
For mitre cuts, the mitre gauge can be turned to
60°in both directions.
To set a mitre angle:loosen lock handle by
turning it counter-clockwise.
Warning:When cutting with mitre gauge, the
lock handle must be firmly tightened.
Using push stick
The push stick serves as an extension of the hand
and protects against accidental contact with saw
blade. The push stick must be used if the distance
between band saw blade and a rip fence is less
than 150mm. When the push stick is not used, it
can be stored on the hook provided at the band
saw frame. Replace push stick if damaged.
Sawing
–Set upper blade guide 3mm above the workpiece.
–Place workpiece on the table.
–plug in.
–Start saw.
–Cut workpiece in a single pass.
–Switch off no further cutting is to be done
immediately afterwards.
Push stick
