BS305/BS340 08
Assembly Instructions
Assembly
Avoid unintentional starting of the machine.
During assembly and for all work on the
machine, the power plug must not be
connected to the mains supply.
Carefully remove all parts included in the
delivery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed in the box
content section have been supplied
Note:
Check the power tool for possible damage.
Before further use of the machine, check that all
protective devices are fully functional. Any
lightly damaged parts must be carefully checked
to ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Attaching the Legs
– Lie the band saw on its back with a piece of
timber propping up the base to allow access to
the bottom of the machine.
– First attach the legs to the base using the
M6hex headed bolts and the 6mm flat washers.
– Next fix the long and short horizontal braces
but do not fully tighten them.
– Stand the band saw up on to its stand and then
tighten the nuts fully on the braces.
Assembling the Table
– Place the table onto the band saw and loosely
tighten the nuts.
– Align the table so that the blade sits in the centre
of the table throat and tighten the nuts to secure
the table in this position.
M8X10 socket
head bolts and
8mm flat
M6 X 12 carriage
blots, 6mm flat
washers and M6
hex nut
