TEL:400-860-9760
www.Ludwig-Schneider.com.cn
7
0
1
7
8
7
2
.0
6
0
9
/2
0
1
8
C
H
/E
N
5.Menu Use
EN
Intelligent Integrated 2 Wire, 3 Wire; Split Wall Hanging, Panel Mounting
06. Current tracking mode (0.000 means abnormal tracking; 1.000 means continuously waiting for
tracking)
3 → 4800, N, 8,1. 4 → 9600, N, 8,1.
21. The first group (programmable) upper limit control 22. The first group (programmable) lower limit
control
23. Second group (programmable) upper limit control 24. Second group (programmable) lower limit
control
32. Baud rate 1 → 1200, N, 8,1. 2 → 2400, N, 8,1.
31. Instrument number (for communication network)
25 *, third group (programmable) upper limit control 26 *, third group (programmable) lower limit control
29. Control hysteresis (to prevent frequent relay jitter, 0.050 is recommended)
27. Upper limit audible alarm (programmable) 28. Lower limit audible alarm (programmable)
30. Backlight (delayed off when 0.000 backlight; 1.000 backlight always on)
07. Change rate (every change amount received, 2.000 is recommended)
10. Factory mode (must be 0.000)
(Anomaly tracking means refreshing at all times; waiting for tracking means that the target is refreshed
at the moment of detection, and no current wait for a few moments is detected)
(When the meter sounds an alarm, press any key to eliminate the alarm sound)
Press and hold the SET button for a few seconds, the -XXXX- interface appears, enter -0000- and
press the SET button to enter the menu loop. To exit, press and hold the SET button for a few
seconds. Required number)
(The factory default setting is to install the height measurement level, and the current is waiting for
tracking)
01. Setting the level (ie the reference setting)
When 04 is set to 0.000, please set the installation height number (analog setting is possible)
(The current H display value is equal to the installation height value minus the air distance value)
When 04 is set to 1.000, please set the actual number of the level (must be set on site)
(The current H display value is equal to the value you set)
Due to the discreteness of the probe and the difficulty of estimating the installation height, it is
recommended to set the current level when measuring with high accuracy
02, range (the current output is proportional to it)
03. Liquid level resection (usually used for measuring flow, 0.003)
04. Mode code setting (0.000 represents installation height mode; 1.000 represents current level
mode)
05.Measuring mode (0.000 represents the measured material level; 1.000 represents the measured
air distance, there is no need to set the distance measurement)
003
