TEL:400-860-9760
www.Ludwig-Schneider.com.cn
EN
7
0
1
7
8
7
2
.0
6
0
9
/2
0
1
8
C
H
/E
N
Ultrasonic Level Meter Menu Simple Setting Operation Instructions
Note: Because the product is constantly updated, the product manual and installation manual cannot
be guaranteed to be consistent with the latest product. If there are changes in the product itself and
the instructions for use, it will not be notified to every customer. If necessary, please contact our sales
staff directly. Changes include but are not limited to the following.
1. Blind zone, performance parameters, function, structure, shape, color, etc. of the product.
2. The function, structure, display mode, and operating habits of the software.
3. Any operation of the hardware must be performed after the power is cut off. If the live operation
causes a short circuit or other fault, it is not covered by the warranty.
The ultrasonic level meter produced by our company, under normal circumstances, according to the
installation requirements of the instructions, after the equipment is installed, you only need to set the
following parameters, the equipment can be used normally.
4. The operation of opening the cover must be performed after the power is turned off, and no liquid
can enter the instrument. If liquid enters and causes failure, it is not covered by the warranty.
There are three keys on the panel, and the instrument can be debugged through these three keys.
The measured value is displayed on the LCD screen after commissioning.
(1) After the meter is powered on, press and hold the SET button for two seconds to enter the first-
level menu.
The menu modes are: expert setting mode and easy setting mode.
Menu lookup table for easy setting mode, as shown in the following table
SET
key
◇ Enter menu item ◇ Move cursor
◇ Confirm menu item ◇ Select menu item
◇ Confirm parameter modification ◇ Parameter modification
key
Easy setting mode menu lookup table
Note: Enter the menu for the first time, please press and hold the "SET" button for 2 seconds,
and press the "SET" button to enter
Please enter probe
emission surface
Distance to the
bottom of the pond
10.00m
Please select to
output
Level or distance
Level value
Level value
Distance value
Please enter 4mA
Corresponding
liquid level during
output
0
.
00
m
Please enter 20mA
Corresponding
liquid level during
output
10
.
00
m
Finish setting
no
no
Yes
Setting
parameters
Easy setting
mode
For the menu query table of the expert setting mode, see "Six, menu interface and operation instructions:".
08
