Ringer
Volume
Control
Handset
Jack
Jack
Handset Cord
Jack
Line Cord
FIGURE 5
4
5
Insert one of the plugs on the handset cord into the jack on the bot-
tom front of the terminal. Insert the other end of the handset cord
into the jack on the handset.
Flex the plastic window over the number card to remove it. Write or
type your telephone number on the card. Replace the card and win-
dow. Install the access codes card and the faceplate cover.
Wall Installation
To mount your terminal on a wall, you may need a hammer, a drill and a
1/8” drill bit, four 1/8” x 2” screws and mounting sleeves, cutting pliers,
and a screwdriver.
Assemble the wall mount. The pieces of the wall mount come
1
attached to one another.
●
●
●
Cut the runner away from the base using cutting pliers. Twist out
the wall support piece.
Use a screwdriver to remove the 4 rubber feet from the base.
Turn the base upside down on a table and insert first tab B, then
tab A on the wall support piece into the corresponding slots on
the base.
iss 1, 7102A VT-4
