Top climate system
with LUBING Touch Controller
Copyright © Lubing System - All rights reserved
38
5.7.8 Software update performance
Before you start the updating process please observe the following
safety notes:
1. Shut off the power supply.
2. Open cover of the controller.
3. Remove microSD card of the card adapter and put it into the slot
which is located on the main-board (fig. 1).
4. Close cover of the controller.
5. Connect controller to the power supply
6.
Press option key on the touch screen and select menu “System
parameter” (fig. 2).
7.
Select parameter “Software Update“.
8.
Enter password
1949
.
9.
Choose the required software version from the list (fig. 3). Confirm
with OK.
f
The system will restart with the new software version.
* Not all brands of MicroSD cards are accepted. Preferably use XLYNE 16GB or Intenso 16GB. Can be ordered
under item no. 55 11 052.
6. MAINTENANCE
Despite the integrated
monitoring and alarm function, the system must be monitored by qualified personnel
regularly. On climatically extreme days, the system should be checked several times a day.
Check the system regularly for leaks in seals, fittings or valves and repair them. Also check the function of all
components and pay attention to changes in the operating conditions. The instructions in section 6 “Troubleshooting”
can support you doing this.
Spare parts
Only use original spare parts, otherwise the warranty will expire. Wear parts are excluded from the warranty.
Piston pump instructions
Before each start-up, check the oil level in the crankcase of the piston pump and refill if necessary (15W-40).
First oil change after 50 operating hours, then at intervals of six months or after max. 500 operating hours.
Good lubrication is the simplest, most effective and cheapest maintenance.
Ensure safe and environmentally friendly disposal of operating and auxiliary materials.
It is also recommended to regularly check the condition of the seals and valves in the pump head. In the event
of leaks, the defective seals and other defective parts must be replaced if necessary. If the pump flow rate is
insufficient, this may be caused by worn valves.
Filter unit instructions
Check the condition of the filter cartridges regularly. If they are very dirty, replace them. Regular replacement (e.g.
once a year) is recommended. Make sure that the order of the filter cartridges is correct. When replacing used filter
IMPORTANT INFORMATION
It is possible to update every Touch Controller with a new software
version in order to activate new features.
The new software version will be installed via micro SD card*.
DANGER!
Warning of electrical hazard!
– Before working on the electrical equipment always shut off
the power and prevent from unexpected restoration of power.
– Touching live parts, or parts that have become live due to
faults, poses a direct risk of death.
NOTE
Please note for pump units with belt drive: The motor shaft and the drive of the pump must be aligned.
Check the belt tension regularly. Excessive V-belt tension can shorten the service life of the bearings and
the belt!
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
