Top climate system
with LUBING Touch Controller
Copyright © Lubing System - All rights reserved
21
Required assembly tools:
Open-end wrenches (size 17/19/22), oil
The basic requirement for installation is a right-angled cut pipe end that is clean and burr-free.
Proceed as follows during assembly:
–
Lightly oil the cutting ring and thread
–
First push the union nut onto the pipe, then the cutting ring with cutting
edge pointing towards the pipe end.
–
Screw on the union nut by hand until you feel the contact. Press the pipe
against the stop in the inner cone.
Note: Non-contact of the pipe end with the stop leads to incorrect assembly.
–
Tighten union nut max. 1/2 revolutions. Hold the screw connection piece
with a wrench. The pipe must not rotate.
–
To check correct assembly, loosen the union nut and check whether the
visible collar has formed on the pipe in front of the cutting edge (collar throw-up).
Then retighten the nut.
–
After each loosening, the union nut must be tightened without increased
effort.
Never load screw connections with bending.
–
Always mount the nozzle lines in their final position and support them during
assembly.
–
Do not mount nozzle lines on the ground.
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
