LSS MasterPort 2, Manual

Page: 53 / 68

MasterPort 2
LSS
53
PSU
The submenu PSU corresponds to the device menu Config → PSU. This submenu sets the following
settings:
Selection Meaning
Maximum cur-
rent Setting of the threshold for the current monitoring.
Control mode
PSU Setting the switching behaviour
On:
Service mode! Do not use in normal operation!
Sense: The Power-DMX port is automatically switched off when
the set current limit or the maximum current of 5A is
exceeded. The manual adjustment of the limit is set in the
submenu MaxCurr.
DMX: Here the DMX address is set. Via this address the
Power-DMX port is controlled. Current monitoring is active
and corresponds to the settings of "Sense".
Off: The Power-DMX port is disabled manually.
DMX Channel Setting the DMX address for the control of the Power-DMX port.
Never use the switch setting "ON" in continuous operation! This setting is for ser-
vice purposes only! A continuous load of more than 5A may destroy the MasterPort
2 and the entire lighting system!
Reset the current monitor remotely when a DMX address for the port was set
Is the Power-DMX port automatically switched off because the set switching
threshold is exceeded, the port can reset remotly. Providing that a DMX address for
the port was set, the port must switched off and on again remotly. All settings are
retained.