LSI-Robway RCI-1550 HRT, Instruction Manual

Page: 70 / 126

Page 67 of 72
Re-assemble reel in reverse order, paying particular attention to correctly locating cable
compartment boss onto shaft and that socket screws are correctly located in shaft dimples.
Use Loctite “Screwlock.”
Unit may now be fully re-assembled and full setting up procedure, (installation may be
completed.
8.4.1.2 Replacing the Payout cable
Reading through the instructions for changing a spring will help with fitting a replacement
cable.
You can save time and effort if, when removing a damaged cable, having disconnected at the
slip-ring, the old cable is used to pull a drawstring through the shaft. The drawstring can be
fixed to the end of the new cable to draw through the shaft.
Ensure that cable glands or seals are all correctly fitted and that reel rotates freely.
8.4.1.3 Safety
At all times, when handling spring operated cable reeling drums, keep full control of rotation.
Be very careful, when handling loose rewind springs, to ensure that all of the coils remain
within the captive band.
8.4.2
13m/26m/35m Recoil Drums
In normal use little attention is required.
Periodically, simply observe that reel behaves correctly when extending and, retracting cable
without hesitation. Check wound cable for damage at anchor pulley and generally.
At major machine service intervals, remove reel cover and check that interior is clean and dry.
Check sliprings are clean with no signs of arcing. Check collector brushes are correctly
located on rings and, that brush spring pressure is being maintained. Replace cover making
sure that seal is located correctly all round.
8.4.2.1
Rewind Spring Mechanism
In the unlikely event of rewind spring failure, the reel will require to be removed from the
machine on which it is fixed.
With the reel on the bench, remove cover and disconnect potentiometer from engagement, tie
back spring loaded arm, disconnect wiring which passes through the reel shaft.
File : 1550-Telescopic-HRT.DOC
Issue Date: - 01/08/05