LRX single, User Manual

Page: 15 / 21

LRX SINGLE
Check on line for the latest updates at www.lrx-lighting.com
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
15
15
LAMP INSTALLATION

A number of hazards exist during lamp installation please refer to
safety warnings on page two.

Follow lamp manufactures instructions regarding use and handling of their
product.

This fixture has more than one power supply. Disconnect all power supplies
before installation or removal of the lamps.

Allow lamps to cool before removing.

Prior to installing the lamp, check lamp contacts and wire ends for signs of
arcing or over-heating. If lamp contacts or wiring appear damaged remove
from service.

Ensure power supply matches lamp type, voltage and wattage.

The required lamp should be fully seated when installed and firmly locked
in place using the lamp lock tool supplied.

NOTE: the Metal halide lamp manufacturers suggest operating the lamp
with the lamp support rod up, as it produces a more stable arc.

Lamps should be wiped with 99% alcohol and clean paper towels or lint free
cloth after installation.

Clean, close and lock the lens.

Close and secure the lamp lock door.

Heat shield must always be used in front of the lamp. This provides
protection for the lens from rain and also helps to contain the glass
fragments in event of lamp breakage.

Ensure power supply matches lamp type and wattage. The use of dimmers
for tungsten lamps is strongly recommended.

Bringing tungsten lamps to full power without pre-warming the bulb and
fixture may break the U.V. lens.

Check gel fan and lamp fan for proper operation. When control power is
applied to the fixture, the lamp fan will start and run for ten minutes then
shut off, the gel fan will start and run for ten seconds then shut off. The
lamp and gel fan will restart when power is applied to the lamp and run for
ten minutes after power is removed from the lamp. It is very important to
leave control power to the lamp after it has been shut off to allow for fan
cooling of the lamp and housing. Overheating can damage the lamp and
internal components.