LRX SINGLE
Check on line for the latest updates at www.lrx-lighting.com
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
4
4
FIXTURE ADDRESSING
Fixture addressing is performed at the rear of the fixture hanger assembly.
The fixture can be programmed to operate in DMX mode or FIXTURE mode
(for use with the hand controller). Because each LRX fixture requires sixteen
DMX channels for operation, FIXTURE mode is merely a convenient way of
skipping DMX channels in 16 channel increments, beginning with DMX
channel #001. Additionally, fixture mode provides power to a connected hand
controller, which is also designed to work in 16 channel increments.
DMX Connector pin out: (also see important note below)
Pin 1 = ground
Pin 2 = Data negative
Pin 3 = Data positive
Pin 4 = 12VDC negative
Pin 5 = 12 VDC positive
When the LRX fixture is in FIXTURE mode, pins 4 & 5 on the DMX IN
connector become energized to 12VDC to supply power to the hand controller.
No power is supplied to pins 4 & 5 when in DMX mode. Ensure that fixture is
in the correct mode prior to connecting DMX lines. Always connect the hand
controller to the fixture with the power off. Damage could result if attempting
to connect the hand controller to the LRX fixture while the power is on.
The mode (square icon) on the left is used to toggle between DMX mode and
FIXTURE mode. FIXTURE mode is designated by a capital ‘F’ in the left-most
digit, with the remaining two digits indicating the fixture number. E.g.
F01=fixture#1, etc. DMX mode is shown as a three digit number from 001 to
512. Once the mode is selected the fixture number or DMX address can be
increased or decreased using the up/down arrows on right side of the switch
assembly. When the correct FIXTURE/address has been selected, the store
(round icon) button second from the left is pressed and held (until the display
stops flashing) to store that address.
It is important to note that the LRX
fixture will not begin responding to a newly selected FIXTURE/DMX address
until it has been stored by pressing and holding the store (round icon) button.
If the display is flashing, this is a warning that the displayed FIXTURE/DMX
address does not match the address that fixture is currently responding to.
Saving the displayed address tells the fixture to begin listening and responding
to the new address. If the address is not stored within five seconds it will
return to the previous set
