LRS T7501, User Manual

Page: 38 / 84

Page 6-4 T7501
Range Test
This test determines if the pagers can be paged in all operating locations.
Although range may vary slightly during busy times, this generally shows where
guests can roam.
Do not perform a range test when guests have pagers
because they will flash all at once. To begin test:
1. Press Setup .
2. Select System.
3. Select Diagnostics.
4. Select Range Test.
5. Press Enter to start the test and Exit to cancel.
6. Take 2 or 3 charged pagers and walk around the area. The pagers flash
about once every 3-4 seconds.
7. The point where the pager does not flash consistently is the maximum range.
8. Press
Enter to end the test.
Program Pagers
LRS Guest and Staff pagers can have their identification number and system ID
changed using the T7501. To Program pagers:
Pizzas, Lobsters, and AdverTeaser Guest Pagers
1. Press Setup
2. Select System
3. Select Diagnostics
4. Select Program Pagers
5. Press Enter to start.
6. Select Coaster and Enter .
7. Select:

Pager IDs if programming individual pagers

Broadcast system ID if changing all the pagers to a new System or turning
all their vibrators on or off.
8. Press Enter .
9. Select vibrator on or off and press Enter .
10. Enter the number to use on the pager and press Enter .
11. Remove pager from the charger (all pagers if using Broadcast function) and
wait until they stop flashing/vibrating then press Enter .
12. Repeat with all pagers to be programmed.
Rechargeable (Star) Staff Pagers
1. Press Setup .
2. Select System .
3. Select Diagnostics
4. Select Program Pagers