LRS T7501, User Manual

Page: 30 / 84

Page 5-4 T7501
To Setup T7501 Static IP
1. Press
Setup Key
2. Enter access code 2 9 1 6 3 and press Enter .
3. Select Network (Icon or from List).
4. Select LAN Wizard (Icon or from List).
5. Select Static and press Enter key.
6. Enter:

IP address

Subnet mask

Default Gateway
7. Press Enter
8. Setup:

Primary DNS server

Secondary DNS server
9. Press Enter
10. Cycle the 9Vac power
Basic System Tests
Initial T7501 Power Up
When power is applied, the T7501 transmitter begins the initialization steps:
1. Screen is blank while the keyboard lights flash.
2. The screen shows a booting sequence.
Note: If using Click Ahead seating the time will be automatically set from the
Internet service. If not a pop up screen requires the local time to be set.
3. The Wait List and Table Status screen appears
4. The INFO, EDIT, Up Arrow, Down Arrow, and Wait List Buttons are lit.
5. The unit is ready for operation.
On Premise Guest and Staff Pager Range Tests
NOTE : Access Code is needed for Setup functions (T7501 Custom Setup).
Perform this test to see if the pagers can be paged in all operating locations.
Although range may vary slightly during busy times, this generally shows where
guests can roam. Be sure pagers are fully charged and/or have good batteries
and are on.
Do not perform a range test when guests have pagers because
they will flash all at once. To begin test:
1. Press Setup .
2. Select System ,
3. Select Diagnostics ,
4. Select Range Test
5. Press Enter to start the test and Exit to cancel.