Programming Pagers
Pager numbering and mode setup is used to renumber or set up individual pagers.
Note:
Be sure to refer back to “Paging Types in Mixed Systems” section to ensure that pagers are
programmed using appropriate crossover points.
Individual Pagers
Note:
Rechargeable pagers can have their System ID’s changed or their vibration turned on or off
as a group.
1. Press SETUP and enter Password.
2. Press F2 (DN).
3. Press 1 (1: Program).
5. Press 1 (1: Prg Pager).
7. At the Select Type menu, select the basic type of pager you are re-programming (Guest pagers or
Staff pagers).
Non-Alpha Guest Pagers (AdverTeaser (Paddle Pager), Coaster Pager, Pizza Pager, Lobster Call)
This procedure is repeated for each pager being programmed. Two charging bases are suggested for pro-
gramming Coasters, Pizza pager, Lobster Call.
1. Place all guest pagers to be programmed on one charger base, leave the second base empty. Pad-
dle pagers may be replaced into the same slot in the charger.
2. Complete the steps for programming “individual Pagers”.
3. At the Select Type menu, press 1 (1: Guest Pagers).
4. Enter Pager Number and press Enter.
5. Select Pager type 1) Coaster Page or 2) Paddle Pager.
6. Select if Pager should Vibrate F1 (Yes) or F4 (No.)
7. Remove the guest pagers from the charger.
8. When flashing stops, press ENTER.
9. The coaster/pager will slowly vibrate and light up then dim to off to indicate it is being pro-
grammed.
10. When programming is finished, put the coaster on the second charging base or the Paddle pager
back into its slot.
11. Repeat steps 2 through 10 for the remaining coasters/pagers.
12. When finished remove all of the coasters/pagers from the charging base and page each one.
13. Reprogram any that do not page.
Guest Alpha Coasters
This procedure is repeated for each pager being programmed. Two charging bases are suggested for pro-
gramming Alpha Coasters.
Note:
Guest Alpha Pagers numbers must be above POCSAG start.
1. Put all coasters to be programmed on one charger base, leave the second base empty.
2. Complete the steps for programming “individual Pagers”.
Long Range Systems
27
Freedom User Manual
