I185 GB 06 15
LRX D01
69
The preset frequency and pulse number can be constant or other function current value. They are variable if the preset are other data code. The
PLSY will stop output if it has outputted the number of
. pulse. PLSY will run again if it is enabled for a second time.
Example:
Parameter setting:
= 500Hz
= 5, output as shown below:
PLSY MODE
Only P01 can work under this mode, and the output is Q01. PLSY has 6 parameters for proper configuration. The table below describes the
information of PLSY parameters.
PLSY stops outputting when the number of output pulse is completed.
In the example below, the frequency is other data code (C01). So the wave frequency will change following the current value of C01.
– In the example above, frequency is 1000 if the current value of C01 is bigger than 1000.
– PLSY stops outputting pulse after it has output 100 pulses.
– PLSY will be going on as long as it is enabled if
is 0.
Enable
1ms
Output
2ms
1
2
3
4
5
10
Symbol
Description
1
PLSY mode (2)
2
Total number of pulse (storing in DRC9)
3
Preset frequency of PLSY (1~1000Hz)
4
Preset pulse number of PLSY(0~32767)
5
Output port (Q01)
6
PWM code (P01)