G-Link
®
-LXRS
®
Wireless Accelerometer Node
User Manual
System Operational Overview
15
NOTE
Automatic node discovery may not work in some boot-up modes. If the node is
not in normal boot up mode, the assigned one can be bypassed to enable node
discovery. For more information
see Troubleshooting on page 43
1. Right-click on the gateway name and select Add Node > Node Discovery (
).
2. Turn on the node with the node power switch. Within a few seconds during power-up,
the node will transmit a message with its operating frequency.
3. When the device status indicator on the node ends the rapid flash sequence and
begins pulsing at one- second intervals, it has completed the normal boot- up
sequence and is running in idle mode. At this point the node should be listed in the
Controller window, and scanning can be stopped by selecting the Stop button in the
Node Discovery window.
Figure 6 - Using Node Discovery
