1. Sensors
1.1 Motor sensor
The walking bike has an electric
magnetic sensor. It registers the
movement of the treadmill and it
activates the motor. However. if the
sensor is too far from the magnet. the
motor won't work. You can reach the
sensor and magnet by unscrewing the
protection cap. The cap is fixed with
three screws [see images 1. 2 and 3 in
the appendix] Next to the magnet you
will find the Allen screw with which
you can adjust the magnet [see image
4]. In case the
AUTO button is on and
the treadmill
is not moving, the magnet needs to
be adjusted closer to the sensor. After
adjustment. ensure that the Allen screw
is correctly tightened!
1.2 Brake sensors
The wiring of the handbrakes contains
an electronic cable that transmits a
signal to the brake sensors. When
you pull either the left or right
handbrake. the red light on the right
and left sensors come on
[see image 5 and 6]. As soon as one
of the red lights is on. the power to the
motor is cut off.
NOTE:
In case the red lights are
on and the brakes were not
activated. your Lopifit won't work and
you'll have to adjust the brake sensors
[read 1.3].
1.3 Adjusting the brake sensors
Start by turning adjustment bolt
counter clockwise a few turns [see
image 5]. Pull and release brake handle
a few times and see if the light has
gone out. If it has, turn adjustment light
clockwise to secure the position of the
adjustment bolt.
�
lop1flt
®
NOTE:
Be careful not to adjust
the brake too tight. In that case
the sensor will stay activated. Relax the
brake as described in chapter 5.2.
Lopifit Instruction Manual -
Page 4
