10
Installation
(for qualified installers only)
© Travis Industries
4160713
100-01442
Top to Rear Vent Modification
NOTE: If using the rear vent configuration, make sure to review vent
configuration before proceeding.
Remove the cast iron stove top and flue cover to access the vent components (see page 28)
Remove the outer flue
assembly, cover plate, and
gaskets. Place the screws
and components aside (for
all subsequent steps).
NOTE: Use a magnetic-tipped
nutdriver on these screws - take
care to prevent the screws from
falling into the intake channel.
Remove the
diffuser.
Before (Stock - Position # 1)
After (Position # 2)
DIFFUSER SIDE VIEW
Bend the round portion of the
diffuser so it is bent (position # 2).
Replace the
diffuser.
ADJUSTING THE DIFFUSER ON THE INNER FLUE ASSEMBLY
Rear vent configurations with no rise require the
diffuser to be bent to the # 2 position. It is easiest
to adjust this component with the inner flue
removed. See the directions below.
Bottom of inner
flue assembly
a
b
c
Remove the inner flue
assembly and exhaust cover
plate.
Inner Flue
Assembly
Exhaust Cover Plate
