11
5. Operating the Viper nt
5.4 control choices
You may control the
Viper nt
externally through the XLR sockets [6 and 8].
Please note
: DMX takes priority. That means: when the machine is controlled via DMX
512 this data takes priority over 0-10 V (+) DC and Stand alone operation.
5.4.2 0 - 10 Volt (+) DC control
Connect the
Viper nt
to an analog desk or with the cable remote (available as an op-
tional extra), using the 3pin XLR socket [6] at the back of the machine.
Please note
: With analog control the pump can be adjusted from the desk and/or the
cable remote. The pump should be pre-adjusted at 99% at the machine.
Please note
: You can‘t use the Mode-button for scrolling through the Menu. The Mode-
button has to be pressed momentarily. If the Mode-button is pressed and hold more
than two seconds, the machine will change into the Timer-Mode (see point 5.5).
a) Connect the cable from the desk or the cable remote into the 3pin XLR socket at the
back of the machine [8].
b) Adjust the pump level at 99% at the machine. The knob on the cable remote or the
fader on the analog desk will now control the level of the pump.
c) Pressing the On/Off switch at the cable remote starts the fog process, the green
On-LED [18] illuminates.
5.4.1 Operating via DMX 512
Connecting the
Viper nt
to a DMX-desk using the 5pin XLR socket [8] on the back of
the machine. As soon as the machine receives a correct DMX signal, the yellow DMX-
LED [17] shines.
a) Press the Mode-button [14] at the control panel, until three figures will appear on
the LED display [18].
b) Adjust the requested start address by pressing the Up/Down-buttons [15].
c) Save the start address by pressing the Enter-button [16] once. The start address will
also be saved when you disconnect the machine from the mains supply.
5.4.1.1 Adjusting the DMX start address
Summary of Contents for Viper NT
Page 2: ...1 Operating manual a Look Solutions product viper nt...
Page 20: ...19...
Page 21: ...20 a Look Solutions product...