5
Warning
The FlashGel™ Power Supply has been tested and found to comply with the limits of CE
regulation. The power supply is marked with ETL which indicates it conforms to US and
Canadian product safety standards. The device also complies with RoHS, indicating it’s
free of certain hazardous substances associated with electrical and electronic equipment
which meets the environmental directive. These limits are designed to provide
reasonable protection against harmful interference when the instrument series is
operated in a commercial environment. This instrument used together with the
FlashGel™ Dock or other electrophoresis chamber, uses, and can radiate, radio
frequency energy, and if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this instrument in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at their expense. Changes or modifications not
expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. It is strongly recommended for the user to read the
following points carefully before operating this equipment.
1. Read and follow the manual instructions carefully.
2. Do not alter the equipment. Failure to follow these directions could result in personal
and/or laboratory hazards, as well as invalidate any warranty.
3. Use a properly grounded electrical outlet with correct voltage and current handling
capacity.
4. Disconnect from power supply before maintenance and servicing. Refer servicing to
qualified personnel.
5. Do not use the unit if there is any sign of damage. Replace damaged parts.
6. Do not use in the presence of flammable or combustible material; fire or explosion
may result. This device contains components which may ignite such materials.
7. Refer maintenance and servicing to qualified personnel.
8. Ensure that the system is connected to electrical service according to local and
national electrical codes. Failure to make a proper connection may create fire or
shock hazard.
9. Use appropriate materials and operate correctly to avoid possible hazards of
explosion, implosion or release of toxic or flammable gases arising from overheated
materials.
10. The unit shall be operated only by qualified personnel.
Summary of Contents for FlashGel 57024
Page 2: ......
Page 18: ...16 Notes...