Loma IQ3X, Operating Instructions Manual

Page: 43 / 88

43 Operating Instructions
Original Document Copyright © Loma Systems
4.7 Configuring the Metal Detector
Wherever possible, configuration of the metal detector will be carried out by Loma Systems
before the machine is dispatched, or by a Loma Service Engineer during a commissioning visit.
Primarily, the commissioning visit is required as part of the installation process so that the
engineer can optimise machine performance in its actual working environment and for the
products that are to be inspected.
There are circumstances, however, where it may be necessary for the end user to carry out some
or all of the configuration and commissioning procedures. Typically, this would occur when
Loma Systems do not have enough information about the end application, such as the belt
speed or reject details, to fully configure the machine.
Options and parameters available for configuring the metal detector are listed and described
below.
Setting Up the Search Head
Setting Up the Conveyor
Setting up the Service Options
Setting the VF Balance
Setting the VF Drive
Setting Up the User Options
Operating Instructions
Performing a Ferrite Tune
Operating Instructions
Setting Up the Reject Options