English
35
START – IGNITION PROCESS
The ignition process may take approx. 5 – 8 minutes until the first
flame is visible (depending on cleanness of the fire trough).
If the 1st ignition attempt is unsuccessful, a 2nd attempt is started
automatically. This may occur if the screw conveyor is not complete-
ly full during the ignition process (e.g. first start after refilling empty
container).
Please observe:
In the event of false start, completely empty fire trough and dispose
of unburned pellets and ash. Never replace unburned pellets from
the fire pot in the supply container.
FIRE HAZARD DUE TO RESIDUAL
EMBERS.
Key
Display
Description
IGNITE
START
EASY 35
Pressing
starts the unit.
This is shown by IGNITE in the display; this is
replaced by START after a brief time.
EASY xx appears in the display after the start
phase (xx stands for a value between 30%
and 100%, depending on output)
If switching off occurs again 50 sec. within switching on (
key)
(at least 2 sec.
key), the pellet stove returns to inactive status.
If switching off occurs during the ignition process (IGNIT or START)
(at least 2 sec.
key), IGNIT OFF or START OFF appears in the
display and the burn-out phase is initiated (duration approx. 10 min).
EASY 40 – OPERATION
Key
Display
Description
EASY 40
Standard display for stove switched on in
simple heating mode. (40 is the output in %)
+
EASY 45
Pressing
+
increases output by 5%
-
EASY 40
Pressing
-
decreases output by 5%
EASY 40 – SWITCH OFF
Key
Display
Description
STOP
EASY OFF
Pressing
initiates the burn-out phase.
The unit switches off after completion of the
burn out phase.
+
Change heat output by
pressing the + or – key
(change in 5 % increments)
-
Summary of Contents for INDALO
Page 2: ...2 A...
