TYPES OF OPERATIONS
Logicube SuperSonix-
NG™ User’s Manual
52
5.3.3 Job Info
The Job Info setting allows users to enter some information about the job. Job Info is not
required to start a Clone, Hash, or Wipe/Format operation.
Information entered here will appear in the logs. More information on the Job Info screen
can be found in
5.4 Task Macro
This operation allows up to five (5) macros that can be set. Each macro can run up to
nine (9) tasks sequentially (one after another). For example, a macro can be set to
perform these tasks in order: Wipe then Clone.
Each of the five macros can be set by tapping on the Macro number on the top of the
screen. Each task or operation must be set up before setting up the macro. For example, to set up a Task
Macro that will perform a wipe, then clone, users must first set up both the wipe and clone tasks. Once the
wipe (for example, Wipe 1) and clone (for example, Clone 1) has been set up, the Task Macro can be set.
5.4.1 Tasks
Tapping this icon allows the user to set specific tasks for each macro.
Tap
Operation 1
to set the first operation in the macro. The following screen will appear
allowing the user to choose the task. Tap the
OK
icon to continue.
Example: Setting up a Macro for a Wipe using Secure Erase then perform a Drive to
Drive Clone
To set a macro to perform a Wipe using Secure Erase on T1, immediately followed by
performing a Drive to Drive Clone from M1 to the newly wiped (secure erased) T1, the
Wipe and Imaging Tasks first need to be set up.
