USER MANUAL SMARTneo //
PAGE 8
WARNING
Danger due to continuous operation
The motor control unit is not designed for continuous operation.
Changing the table top position without disruption must not
exceed the duty cycle specified on the rating plate!
DANGER
Danger due to defective power supply cable
Always use a standardized power supply cable. Ensure that the
power supply cable is not damaged. Operation of the motor cont-
rol unit with a damaged power supply cable is prohibited.
DANGER
Danger due to self-built products
Connecting self-built products on the motor control unit is
prohibited. Use only components suitable for LOGICDATA
motor control units as the device may otherwise be damaged or
destroyed.
DANGER
Remove from the electricity network before plugging
Before plugging hand control in and out, you have to pull the
power supply cable from the mains plug without fail.
DANGER
Danger due to malfunction
With a malfunction (e.g. if the motor control unit continues to
run independently when a movement button is stuck), the mains
plug must be pulled immediately.
DANGER
Danger due to humidity
Protect the motor control unit against moisture, dripping and
spray water!
DANGER
Danger due to changes to motor control
Conversions or changes to motor control unit and control ele-
ment are prohibited.
DANGER
Danger of crushing
In the event of a malfunction (motor or module error), it can
happen that the table top moves a bit with every attempt to start
before the safety shutdown engages. Please note the increased
crushing hazard hereby!
