DYNAMIC MOTION SYSTEM - SYSTEM MANUAL // PAGE 24
6.2 ADVANCED FUNCTIONS
This section describes functions that can only be performed by certain Comfort Handsets alongside the
DYNAMIC MOTION system. Consult your User Interface's Manual for instructions and safety advice.
6.2.1 KEY LOCK
CAUTION
Risk of minor or moderate injury through uncontrolled movement
When attempting to activate the Key Lock, pressing the Handset too forcefully may
cause the table to move unexpectedly. Failure to anticipate the table's movements may
lead to minor or moderate injury through crushing.
• Do not press the Handset too forcefully while activating the Key Lock
INFO
The Handset must be turned on for the Key Lock to be activated. To activate a locked
Handset, press any key.
INFO
Key Lock is only available as standard on certain models. If your Handset supports Key
Lock, the feature can be activated during parameterization.
Activating the Key Lock prevents you from moving the table if you accidentally press a Key. The Key Lock
can be activated and deactivated by swiping across the bottom edge of the Handset. Alternatively, swipe
horizontally across the left or right-hand side of the Handset (Fig.9). The display must be active for you to
activate the Key Lock. To activate an inactive display, press any Key. After you have activated the Key Lock, a
key is displayed on the screen (Fig.10).
Fig. 6:
Activating the Key Lock
Fig. 8: Locked Handset
6.2.2 CHANGING THE DISPLAYED UNIT OF MEASUREMENT (CM / ")
Most Comfort Handsets can display the height of the Table Top in both centimeters and inches. To change
the displayed unit of measurement:
1 2
Press and hold the following Keys for 3 seconds:
• Memory Position Keys 1 and 2
• UP Key
▸ The display shows
S and a number
, e.g.
S 7
.
2. Press the button
UP Key
until the display shows
S 5
.
▸ The display shows
S 5
.
3. Press the
SAVE Key
▸ If the display was previously set to cm, it is now set to inches.
▸ If the display was previously set to inches, it is now set to cm.
SAVE
