24 //ADJUSTABLE BED FRAME - OWNER’S MANUAL
DISASSEMBLY
7RGLVDVVHPEOHWKH$GMXVWDEOH%HG)UDPH\RXPXVW¿UVWGLVFRQQHFWWKH%HG)UDPHIURPWKH
mains. Then, follow the assembly instructions in reverse order. To minimize the risk of pinching
when transporting the Side Rails, secure all moving parts with packaging tape.
6. DISASSEMBLY AND
TRANSPORTATION
TRANSPORTATION
After it has been fully assembled, the Bed Frame should only be moved short distances within
the same room. Lifting the Bed Frame requires two people. To lift the Bed Frame:
1. (QVXUHWKDWWKH%HG)UDPHKDV¿UVWEHHQPRYHGWRWKH6OHHSLQJ3RVLWLRQ
2. Stand at opposite sides of the Bed Frame (long sides) and grip the Base Platform.
NOTICE
Moving the Bed Frame on its side or upside down may lead to damage to the product.
• Only move the Bed Frame while it is in horizontal position (Platforms facing upwards)
• 'LVDVVHPEOHWKH%HG)UDPHEHIRUHPRYLQJLWWRDGLႇHUHQWORFDWLRQ
CAUTION
Risk of minor or moderate injury through crushing
Tilting the Bed Frame when lifting or moving the Adjustable Bed Frame may lead to minor or
moderate injury through crushing.
• Keep the Bed Frame level while lifting or moving it
• Do not attempt to lift or move the Bed Frame alone
25
ADJUSTABLE BED FRAME - OWNER’S MANUAL //
CLEANING
NOTICE
Cleaning agents, such as non-alcohol based cleaners, sanitizers, and others can destroy the
anodized layer of the Adjustable Bed Frame. Use only a dry or slightly damp lint-free cloth to
clean the Bed Frame
MAINTENANCE
The Adjustable Bed Frame does not require maintenance. If the Bed Frame becomes damaged,
RULI\RXDUHH[SHULHQFLQJWHFKQLFDOGLႈFXOWLHVFRQWDFW/2*,&'$7$XVLQJWKHGHWDLOVRQSDJH
7. CLEANING AND
MAINTENANCE
WARNING
Moderate risk of death or serious injury through electric shocks
Leaving the Bed Frame plugged in while cleaning it may lead to death or serious injury
through electric shocks.
• Use only a dry or slightly damp lint-free cloth to clean the Bed Frame
• Do not allow any of the Bed Frame’s components to become wet during cleaning
• Always unplug the Bed Frame from the mains before cleaning
To clean the Adjustable Bed Frame, use a dry or slightly damp lint-free cloth to wipe the Bed Frame.
26 //ADJUSTABLE BED FRAME - OWNER’S MANUAL
8. TROUBLESHOOTING
BEHAVIOR
The Bed Frame does not
respond when Buttons are
pressed.
Parts of the Bed Frame re-
main in an elevated posi-
tion after a power failure.
POSSIBLE CAUSE / SOLUTION
1. The Bed Frame is not connected properly. Check the power
connection
2. Time-out has been reached due to continuous operation. Do
not operate the Bed Frame for at least 6 minutes. This will re-
set the time-out.
3. Unplug the Power Converter. Wait until the LED goes out,
then plug it back in.
4. Replace the batteries in the Remote Control.
If power cannot be restored, an Emergency Lowering is required.
Proceed as follows:
1. Unplug the Power Converter from the power outlet.
2. Disconnect the Power Converter from the Cable Leading to
the Control Box.
3. Connect the Battery Strap to the Control Box Cable instead.
4. Connect two 9V batteries to the Battery Strap.
5. Use the Head DOWN/UP, Foot DOWN/UP or Sleeping Po-
sition Buttons to drive the Bed Frame to its lowest position.
Once Emergency Lowering is complete and power is restored,
you can reconnect the Power Converter. Then, perform a Ref-
erence Drive (see Chapter 5) and operate the Bed Frame as
normal.
